10

I have a Wemo Smart Switch similar to the one in the picture below.

Wemo Smart Switch F7C027

Using Wemo app from an iPhone the switch can be controlled. I am interested in learning electrical signal behavior of the white wire (as shown in the picture below) which I believe is the one responsible for controlling the Wemo Smart Switch.

wemo smart switch opened up

I have been looking at Belkin WeMo Teardown. Based on the Belkin WeMo Teardown looks like there is Power PCB and Logic PCB. Depending on the switch there appears to be a 3 wire or 5 wire option.

Looking at OpenWrt Wiki Belkin F7C027 it looks like the signals are

  1. White (GPIO13) - AC Relay control
  2. Black - GND
  3. Red - 5V
  4. 3.3V
  5. GPIO14 - 0V off (default) 3.3V on

As state above does anyone know the electrical signal behavior of the white wire? Is the signal a simple High/Low (on/off), pulse (toggle) or something other like a pulse train (data communication)?

6
  • 4
    What do you mean 'electrical signal behaviour'? This is the relay switch, 3.3v GPIO from the MCU, according to the openwrt page. Feb 8 '17 at 19:50
  • @SeanHoulihane, where does it say 3.3V GPIO, looks like I might have missed this information.
    – user8055
    Feb 8 '17 at 20:36
  • Page 7 of the datasheet linked from this page sparkfun.com/products/retired/12655 Feb 8 '17 at 20:45
  • @SeanHoulihane, thank you for pointing out to the datasheet I looked at cdn.sparkfun.com/datasheets/Wireless/WiFi/RT5350.pdf document. But I didn't see any references to GPIO13. I only see pin out and signals
    – user8055
    Feb 8 '17 at 21:06
  • Don't forget to edit to clarify what you mean by 'electrical signal behaviour' so we can answer your question (or, if your problem is solved, feel free to post an answer below to help other people in future!)
    – Aurora0001
    Feb 13 '17 at 17:04
4

In this case, the relay control is just a signal to energise the coil in the relay. It's likely to be a fairly high current (10s of mA) so needs a switching transistor in addition to just the mcu I/O pin (unless the relay is a solid state module, or has a local driver).

Do remember that the components inside this switch all risk being at mains voltage, and if you make any modifications, you put yourself and anyone else in the property in significant danger.

1
  • If you have a better answer, please contribute it :) Mar 15 '17 at 9:43

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.